C-8

ACCESSORIES

C-8

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

DUAL PROCEDURE SWITCH OPTIONS

K683-3 DUAL PROCEDURE SWITCH

Kit includes gun switch and mountings for Lincoln Innershield and Magnum guns, with 15 ft (4.5 m) control cable and 5-pin plug with two leads to con- nect to gun trigger.

Connect the 5-pin plug of the K683-3 Dual Procedure Switch to the Power Feed 10 wire feeder trigger/dual procedure 5-socket receptacle.

The two lead plug cord extending out of the 5-pin plug of the Dual Procedure Switch is to be connected to the two trigger leads of the welding gun per instructions shipped with the kit.

K683-1 DUAL PROCEDURE SWITCH

The K683-3 Dual Procedure Switch is the recom- mended method of obtaining dual procedure; but if it is desired to use an existing K683-1 with the Power Feed 10, it can be done. A K683-1 Dual Procedure Switch can be used on the Power Feed 10 if a K686- 2 adapter is used. The K682-1 kit includes gun switch and mountings for Lincoln Innershield and Magnum guns, with 15 ft (4.5 m) control cable and 3- pin plug. K686-2 adapter permits 3-pin plug and 5- pin gun trigger plug to be connected to Power Feed 10 5-pin trigger/dual procedure receptacle.

GAS AND WATER KITS

K590-5 WATER CONNECTION KIT (FOR DRIVE ONLY)

Install per the instructions shipped with the kit.

K1536-1 WATER FLOW SENSOR KIT

Install per the instructions shipped with the kit.

K659-1 GAS GUARD REGULATOR

Adjustable flow regulator with removable adjuster key for CO2 and Argon blend gases. Mounts onto feeder inlet, and reduces gas waste and arc start “blow” by reducing surge caused by excess pressure in supply hose.

Install the 5/8-18 male outlet of the regulator to the 5/8-18 female gas inlet on the back panel of the wire drive. Secure fitting with flow adjuster key at top. Attach gas supply to 5/8-18 female inlet of regulator.

CHASSIS OPTIONS

K1557-1 SWIVEL PLATFORM

The K1557-1 Swivel platform attaches to the power source. This kit includes a feeder adapter plate that allows the feeder to rotate on top of the power source. The feeder can be easily separated from the swivel mount at any time. This option is compatible with the K1556-1 Light Duty Caster Kit.

K1556-1 LIGHT DUTY CASTER KIT

This option provides four casters and all required hardware to mount it to the Power Feed 10. This option is compatible with the K1557-1 Swivel Platform.

K1574-1 SECURITY DOOR (LARGE)

K1574-1 Security Door Installation into the Control Box cabinet.

1.Turn off power.

2.Unlatch and swing open the small door. Remove the two screws from the horizontal hinge rod. Save the screws.

3.While holding the door so it doesn’t fall, slide the rod out sideways releasing the door.

POWER WAVE 455/POWER FEED 10

Page 40
Image 40
Lincoln Electric SVM135-B service manual Dual Procedure Switch Options, GAS and Water Kits, Chassis Options