Lincoln Electric SVM135-B service manual DIP Switch Setup, Setting DIP Switches Control BOX

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

A-11	INSTALLATION										A-11
											S1
DIP SWITCH SETUP		ON
			1	2	3	4	5	6	7	8
SETTING DIP SWITCHES IN THE
CONTROL BOX											S2
		ON
			1	2	3	4	5	6	7	8
There are two DIP switch banks on the mother board
of the Control Box. They are labeled S1 and S2 and
			FIGURE A.3
are located and oriented as shown in Figure A.3.

S1 DIP Switch Bank on Control Box Motherboard (For software version S24004-2 only)

	Switch	Off		On
1		US 4-Step Trigger Logic		Euro 4-Step Trigger Logic
2		WFS Display = inches/minute		WFS Display = meters/minute
3		Left Display is always preset WFS		Left Display is preset WFS when weld current is not flowing
				Left Display is actual weld current when weld current is flowing
		CC modes override this switch regardless of position. Left Display is always preset weld cur-
		rent when weld current is not flowing and actual weld current when weld current is flowing
4		Run-in = Minimum Speed Available		Run-in = weld WFS
		If any option containing a Run-in setting is connected to the motherboard, it automatically
		overrides this switch regardless of position.
5		Spare
6		Acceleration, MSB	(Sets acceleration rate for wire drive) see below
7		Acceleration	(Sets acceleration rate for wire drive) see below
8		Acceleration, LSB	(Sets acceleration rate for wire drive) see below

S2 DIP Switch Bank on Control Box Motherboard (For software version S24004-2 only)

Switch	Off		On
1	Network Group ID, MSB	(Assigns Control Box to a specific group) (Off is factory setting)
2	Network Group ID, LSB	(Assigns Control Box to a specific group ) (Off is factory setting)

3Spare

4Spare

5Spare

6Spare

7Spare

8Reserved

Note: the factory shipped settings for all of the S1 and S2 switches is “OFF”.

POWER WAVE 455/POWER FEED 10