Section TOC
Master TOC
F-56 TROUBLESHOOTING AND REPAIRF-56
VOLTAGE SENSE PC BOARD TEST (continued)
FIGURE F.14 — VOLTAGE SENSING BOARD TEST.
Return to
to Section TOC
Return to
to Master TOC
1 2 3 | J2 |
J1 4 5 6
1
2
NOTE: Inspect the molex plug connector pins on the Voltage Sense Board. If any of them are gold plat- ed the P.C. board should be replaced
Return
Return to Master TOC
Return to Master TOC
TEST PROCEDURE
1.Remove input power from the wire feed unit.
2.Using the 3/8 in. nutdriver, remove the cover from the wire feeder.
3.Locate the voltage sense PC board and plugs J1 and J2. Do not remove the plugs from the voltage sense PC board. Refer to Figure F.14.
4.Apply the correct input power (from the Power Wave 455 control cable) to the wire feeder. With the gun trigger acti- vated, check for approximately 12 VDC at plug J1 pin 1 (+) to pin 4
5.With the gun trigger activated and arc voltage present at the conductor block, check for arc voltage from plug J1 pin 3 (lead 67) to the workpiece. If actual arc voltage is NOT present, check the continuity of lead 67 from the conductor block to plug J1 pin 3 on the voltage sense PC board.
6.If the actual arc voltage IS present at plug J1 pin 3 (lead 67), then check for arc voltage from plug J2 pin 1 (lead 67A) to the workpiece. See wiring dia- gram.
7.If the 12 VDC IS present in Step #4 and the arc voltage IS present in Step #5 but the arc voltage is NOT present in Step #6 (lead 67A), the voltage sense PC board may be faulty.
8.Remove all input power from the wire feeder unit.
9.Install the wire feeder cover with the 3/8 in. nutdriver.
