Installation | On−Board Hardware Accessories |
|
|
SLimited Power on PMC Modules and RTMs
The blade does not provide an extra fuse for PMC modules and RTMs. PMC modules and RTMs used together with the blade have to be qualified according to the following standards: IEC 60950−1, EN 60950−1, UL 60950−1, CAN/CSA C22−2 No 60950−1
SExcession of blade‘s power consumption
Exceeding the maximum combined power dissipation of installed PMC modules may damage the blade.a
Make sure that the combined power dissipation of installed PMC modules on the 3.3V and 5V rail does not exceed 60W.
SPMC Module Malfunctioning
Processor PMC modules (as defined in ANSI/VITA 32−2003) can be operated in two different modes: monarch and non−monarch mode.a
Make sure to operate any installed processor PMC modules (as defined in ANSI/VITA 32−2003) only in non−monarch mode.a
SDamage of Installed Hard Disk
If PPMC/270 or PPMC/280 modules are installed into PMC slot 1 or 2, the heat radiated by the heat sink of theses PMC modules heats up an installed hard disk that may be installed at the same time.a
If PPMC/270 or PPMC/280 modules are installed into PMC slot 1 or 2, make sure not to have a hard disk installed at the same time.a
SDamage of Rear Transition Module and Blade
The ACC/ARTM−717 was designed to be used in conjunction with PPMC/270 or PPMC/280 modules modules installed on the blade at the same time.
In order to avoid damage of the blade or RTM, only use the ACC/ARTM−717 in conjunction with PPMC/270 or PPMC/280 modules.
Installation Procedure
1.Connect PMC module carefully to PMC slot
2.Make sure that 15 mm standoffs of PMC module cover mounting holes of the blade.
3.Place screws delivered with PMC module into mounting holes
4.Fasten screws
Removal Procedure
1.Remove screws
2.Disconnect PMC module carefully from slot
48 | PENT/ATCA−717 |
