Installation | On−Board Hardware Accessories |
|
|
1.Position hard disk above blade so that the blade′s parallel ATA or serial ATA or SATA connector faces the hard disk′s interface connector
2.Connect hard disk with blade′s connectora
3.Turn blade to face its bottom side
4.Fasten four screws to blade’s bottom side
Removing a Hard Disk
1.Removing Hard Disk
2.Place blade on table with blade’s bottom side facing you
3.Remove four screws holding hard disk
4.Carefully remove hard disk from blades’s parallel ATA or SATA connector
5.Store hard disk and screws in a safe place in case you want to use the accessory kit components again
CompactFlash Disk
The blade provides a connector to install a CompactFlash card of type I and II.aaa
50 | PENT/ATCA−717 |
