Installation

On−Board Hardware Accessories

 

 

3.Plug CompactFlash into socket

4.Close locking bow over CompactFlash disk

Note:aThe locking bow must enclose the disk completely.a

Removal Procedure

1.Open locking bow

2.Take CompactFlash disk′s ends and pull CompactFlash disk carefully out of socket

3.Close locking bow again

CMC Debug Module

A CMC debug module is available as accessory kit for the blade. It is called ACC/ATCA−CMC−MODULE and provides two serial and one keyboard/mouse interface at its face plate. The CMC debug module is installed into PMC slot 4. For further details refer to theaACC/ATCA−CMC−MODULE Installation Guide.aa

52

PENT/ATCA−717

Page 52
Image 52
Motorola ATCA-717 manual CMC Debug Module, Removal Procedure