Rear Transition Modules | Installation |
|
|
Rear Transition Modules
At the time of writing this manual the following Rear Transition Modules (RTMs) was available for the blade: ACC/ARTM−717aa
It provides the following interfaces:a
STwo USB 2.0
STwo RS−232
SKeyboard/Mouse
SOne serial ATA
SFour RS−232 interfaces routed from PMC modules installed on the base blade
Note:a
SRefer to the RTM documentation for the RTM installation procedure
SCheck the documentation of the system where you operate the blade and the RTM for any restrictions that may apply to the blade or the RTM
SNo hot−swap is supported for the RTMs
The RTM furthermore incorporates an Intelligent Platform Management Interface Controller (IPMC) which enables you to monitor the RTM’s temperature and voltage sensors. For further information, refer to theaACC/ARTM−715/717/7105/7107: Control via IPMI Programmer’s Guideawhich can be downloaded from the former Force Computers S.M.A.R.T. server or the Motorola literature catalog.a
PENT/ATCA−717 | 53 |
