Samsung 7100 manual Calls to a group

			OfficeServ 7100 Call Server Programming Guide
			(continued)
	No	Option	Description
	2	OVERFLOW	This is the timer value that will cause unanswered calls to a group to
			begin also ringing the NEXT PORT(see below) after this timer has
			elapsed. If set to 000, no overflow will take place.
3		GROUP	This is a timer that will determine how long Trunk Line calls transferred
		TRANSFER	to the group will ring at the group before recalling. If set to 000, no recall
			will take place.
4		NEXT PORT	This is the station or group number that callers will also ring at if the OVER-
			FLOW feature has been programmed. The OVERFLOW DESTINATION
			can be defined as:
			1 COMMON BELL There is a common bell port on each MIS card.
			2 RING OVER PAGE The ROP port can be defined as the NEXT port.
			3 STATION OR STATION GROUP. Any station or station group can be
			defined as the NEXT port.
5		MEMBER	List all members that are to be in the group. Up to 32 members for the
			system are allowed in each group, but stations can be assigned to mul-
			tiple station groups.
6		NEXT HUNT	The length of time a call will ring at a station before it hunts to the next
			group member.
7		GROUP BUSY	When this option is set to ON, a busy signal will be sent to the caller if
			all group members are busy. When this option is set to OFF, the ring
			back tone is sent to the caller even if all group members are busy. UCD
			is an exception to this rule. This option only works when MMC 210 SGR
			INC BUSY is set to OFF. When MMC 210 SGR INC BUSY is set to ON,
			all station groups will follow this setting.
	9	ALLOUT NEXT	If all members are log-out, the call would be send to next port.
10		RBT MSG	If set ON, coloring service can be used by using svmi message.

Calls to a group

Calls to a group do not follow the call forwarding instructions of any station in the group.

Samsung Business Communications 2-169