Samsung 7100 manual CTI Link Option, ITP DSP Para, SYS Data, Itp Tx Gain/Hset, Itp Rx Gain/Hset

CHAPTER 2. Ошибка! Стиль не определен.

					(continued)
	No	Option		Description	Default
04		CTI LINK OPTION	Sets CTI link via LAN option with the system.
			0	SMDR REPORT: Sets YES or NO for SMDR data	NO
				to CTI link via LAN.
			1	UCD REPORT: Sets YES or NO for UCD data to	NO
				CTI link via LAN.
			2 ALIVE: This is a CTI link via LAN alive check		300 SEC
				timer. If this is set to 0, the system will not
				check link alive.
05		ITP DSP PARA	Sets IP phone DSP parameter system wide.
			0 M-FRAME: This value determines the trans-		10 ms
				mission interval time of VoIP packets generated
				by the IP phone. This data uses DOWN = SYS
				DATA only(see 3, below). The range is
				10~40 ms.
			1 JITTER: Decides the minimum time to consider		20 ms
				delay for jitter adjustment. This data uses
				DOWN = SYS DATA only(see 3, below). The
				range is 10~90 ms.
			2 TOS: An 8-bit binary value that will be used by		All bits 0
				external routers, switches, etc,(that optionally
				support TOS-bit prioritization) to identify the
				transport-priority value of data packets gener-
				ated by the IP phone. This value can be left at
				the default value(00000) if your network infra-
				structure does not support this method of
				bandwidth management. This data uses DOWN
				= SYSTEM DATA only(see 3, below).
			3 DOWN: Determines whether system-wide data		SYS DATA
				or individual phone data is used for DSP control
				of IP-based phones.
				a) SYSTEM DATA: System-wide data will be
				used.(MMC 841)
				b) PHONE DATA: Individual phone data will
				be used.(MMC 840)
06		ITP TX GAIN/HSET	Sets IP-based phone Handset TX gain value of		Depends on
			each level.		country
07		ITP RX GAIN/HSET	Sets IP-based phone Handset RX gain value of		Depends on
			each level.		country

2-322 Samsung Business Communications