Samsung 7100 manual MGI Parameters

CHAPTER 2. Ошибка! Стиль не определен.

[831] MGI PARAMETERS

This MMC provides a mean to configure the Internet Protocol(IP) addressing of the MGI card(s) in the system.

No	Parameter	Description
0	IP ADDRESS	Specifies the IP address for the MGI card.
1	GATEWAY	Specifies the designated IP gateway address used for contacting
		IP devices beyond the local subnet.
2	SUB MASK	Specifies the IP subnet mask. This parameter is used by the system to
		calculate the range of IP devices(subnet) that are within ‘direct reach’
		of the MGI.(without having to go through the designated network IP
		gateway)
3	IP TYPE	Specifies if the system will be routing data over a public or private
		network.
4	PUBLIC IP	The MGI will originate communications, to IP phones and VoIP
		connections outside the local network, using this IP address. If this
		IP address sets 0.0.0.0, 255.255.255.255 or default value then this
		MGI card uses private IP only. See System IP Type on MMC 830.
5	PUB PORT	Public Port
6	VERSION	No entry required. Used to indicate revision of MGI3 S/W.
8	CARD RESET	Reboots MGI card.
9	IP VERSION	Specidies MGI IP version is IPv4 / IPv6.

MGI PARAMETERS

- IP ADDRESS, GATEWAY, and SUB MASK—any changes to these parameters will not be applied until the MGI card is reset.

-When changing any IP address/value, three digits must be entered for each (octet) field. For example, 192.168.1.10 should be entered as 192 168 001 010.

2-300 Samsung Business Communications