Sharp MX-M700U Changing the copy settings for each set of originals, Touch the CHANGE key

SPECIAL MODES

■Changing the copy settings for each set of originals

When using job build mode, you can change the copy settings each time you place a set of originals. After performing step 4 on page 5-8,follow the steps below.

5 Touch the [CHANGE] key.	7 Touch the [READ-END] key.
INTERRUPT	INTERRUPT

ES ORIGINAL A4 ES ORIGINAL A4

PLACE NEXT ORIGINAL. PRESS [START].		PLACE NEXT ORIGINAL. PRESS [START].
TO CHANGE COPY SETTINGS,		TO CHANGE COPY SETTINGS,
PRESS [CHANGE].		PRESS [CHANGE].
CHANGE	READ-END	CHANGE	READ-END
4.	A3	4.	A3
	C		C

6 Select the desired copy settings in the screen that appears and press the [START] key.

[START].INTERRUPT

	ORIGINAL			A4		READ-END
							AUTO
					A4	EXPOSURE
						AUTO		A4
1.		2.
			5.		A4	PAPER SELECT
A4		B5
3.	B4
						100%
4.	A3

COPY RATIO

The copy settings that can be selected are "EXPOSURE", "PAPER SELECT", and "COPY RATIO".

If you touch the [READ- END] key now, copying

will begin without scanning the new set of originals.

NOTES

●If the original size was set manually at the beginning of the job build procedure, it will not be possible to change the original size setting. If the automatic original detection function is operating, the original size will be detected for each set of originals placed.

●When the bypass tray is selected, it is not possible to change the paper type.

●If "XY ZOOM" was initially set for the ratio, it will not be possible to change the ratio setting.

●When job build mode is used in combination with any of the following functions, the [CHANGE] key will not appear in the screen of step 5.

Pamphlet copy, tandem copy, covers/inserts, transparency inserts, multi-shot, book copy, tab copy, staple sort, saddle stitch

5-9