Sharp MX-M620N, MX-M700N, MX-M550U 3-10, Removing a staple jam in the saddle stitch finisher

FINISHER AND SADDLE STITCH FINISHER

■Removing a staple jam in the saddle stitch finisher

1 Perform steps 1 to 3 of the procedure for "Replacing the cartridge in the saddle stitch finisher" on page 3-8.

2 Remove the empty staple case.

5 Return the staple case to its original position.

3 While pushing down on lever (A), pull up knob (B) .

(A)

(B)

4 Remove any jammed staples, and then return knob (B) to its original position.

(B)	Be sure to remove any
	strips of staples.

Jammed staples

6 Return the saddle stitch holder and the saddle stitch unit to their respective original positions.

7 Make sure that the finisher is firmly attached to the machine and that A3, A4R, or B4 (11" x 17", 8-1/2" x 11"R, or 8-1/2" x 14") size paper is loaded.

If one of the above paper sizes is not set, test stapling cannot be performed.

8 Close the lower cover of the finisher.

Test stapling is automatically performed on a blank sheet.

This operation is carried out to avoid blank stapling.

NOTE

If test stapling fails to take place, repeat steps 1 to 7.

NOTE

Do not touch the stapling area.

The stapler could injure you.

■Disposal of hole punch scrap (when the punch module is installed)

1 Open the cover of the hole punch module.

2 Holding the black handle, slide out the case containing the paper bits, and dispose of them properly.

3 Return the waste case to its original position.

4 Close the cover of the hole punch module.

3-10