Sharp MX-M700U Loading paper in the AR-LC7, Place the paper on the paper table, Loading Paper

LOADING PAPER

■Loading paper in the AR-LC7

If the paper runs out during printing, a message will appear in the display. Follow the procedure below to load paper.

1 Pull the tray out until it stops.

Pull the finger grip up and pull the tray out until it stops.

NOTE

To add or change paper, press the operation button.

When the button is

pressed, the indicator

will blink until the paper

table stops descending.

Do not pull the tray out until the indicator turns off. Attempting to pull

the tray out when the indicator is blinking or solidly lit may damage the tray.

2 Place the paper on the paper table.

	The paper		stack	must
	not be higher than the
	indicator line.
	When the paper tray is
Indicator	pulled	out,	the paper
	table	will		have
line
	descended		to	a
	position		where

approximately 500 sheets of A4 size (8-1/2" x 11") 80 g/m2 (20 lbs.) paper can be placed. After the paper is placed, the paper table will descend to a position where an additional approximately 500 sheets can be placed. When the paper table has descended all the way, approximately 3000 sheets can be held.

If a different type of paper is loaded that was used previously, the paper settings for tray 5 must be changed on the machine. Be sure to change to the appropriate settings as explained in "Setting the paper type and paper size" on page 2-14.

CAUTION

When loading paper, take care not to insert your hands into holes on paper table.

Do not insert your hands here.

2

NOTES

Do not insert objects in the tray or attempt to place spare paper in the tray. This may damage the tray.

●Use SHARP-recommended paper (page 2-22). Special paper cannot be used.

3 Push the tray firmly all the way into the machine.

After the tray is pushed in, the indicator will blink until the paper

table finishes ascending and then light solidly.

2-9