Sharp MX-M700U 5-45, Calling up a job program, Deleting a stored job program, Press the #/P key

STORING, USING AND DELETING JOB PROGRAMS

Calling up a job program

1 Press the [#/P] key.

LOGOUT

2 Touch the number key of the desired job program.

			The	screen
JOB PROGRAMS
			automatically closes and
	PRESS PROGRAM NUMBER.
			the job program is called
			up. A number key that
			does not have a job
			program	cannot be
		RECALL
			selected.

3 Set the number of copies if needed and then press the [START] key.

Copying will begin using the settings of the job program.

Deleting a stored job program

1 Press the [#/P] key.

LOGOUT

2 Touch the [STORE/DELETE] key.

4 Touch the [DELETE] key.

The selected program is

				deleted		and you return
	A JOB PROGRAM HAS BEEN ALREADY STORED
	IN THIS LOCATION.			to the screen of step 3.
				To return to the screen of
	CANCEL	DELETE	STORE
RECALL			STORE/DELETE	step	3	without	deleting
				the job		program, touch
				the	[CANCEL]		key.	In
				both	cases, touch			the

[EXIT] key on the screen displayed in the screen of step 3 to exit the job program mode.

5

M NUMBER.

RECALLSTORE/DELETE

3 Select a storage register number of the program to be deleted.

		If a number key for which
	EXIT
		no job program has been
		stored is selected, the
		screen will change to the
		screen of step 4 on the
		previous page for storing
STORE/DELETE
		a job program.

NOTE

If overwriting of programmed copy settings has been prohibited in the administrator settings, it will not be possible to store or delete a job program. (See page 17 of the administrator settings guide.)

5-45