2.Open the cover of the 15-pin cable jack on each Organizer.

3.Plug each end of the cable into the cable jack on each Organizer.

+To conserve battery power, disconnect the cable as soon as a transfer is completed.

Transferring data

1.Turn on both Organizers.

2.On the OZ-5600 Organizer, open the application in which you want to receive the data.

Only data corresponding to the application selected on the receiving Organizer will be transferred (regardless of which applications were selected on the sending unit).

In the Tel and User File applications, use the menu to switch to the correct destination file.

3.On the OZ-5600 Organizer:

Press MENU four times to open the PERIPHERALS menu.

Select UNIT TO UNIT TRANSFER and press ENTER .

A submenu opens.

Select GET DATA (APPEND) and press ENTER .

A message appears, informing you that the Organizer is attempting to make a connection and receive data from the sending unit.

4.On the sending unit:

Press MENU and select PERIPHERALS. Select UNIT TO UNIT TRANSFER, then select the preferred SEND option.

Repeat the steps above for all applications you want to import to your Organizer.

+Notebook entries from Organizers other than the OZ-5600 will be transferred to the Memo application. All other matching applications will share the same name.

There are some other restrictions. See p.181.

Since the Memo application does not support formatting (tabs, indents, etc.) and styles (bold, italics, etc.), such information contained in entries received from other Organizer models will be ignored and lost.

On the OZ-5600 Organizer, all applications that allow entry of text providen automatic word wrapping at the end of each line. However on 6500 and 9000-Series Organizers, this is not supported. As a result, any entries transferred between these models and the OZ-5600 may be displayed differently in the corresponding applications to the original versions.

9

177

Page 180
Image 180
Sharp OZ-5600 operation manual 177, Transferring data