Troubleshooting 6

Printer’s timeout

Note This is the basic procedure for changing one of the printer’s timeout values. For more information on the printer’s timeouts, refer to the on-line manual on the printer’s CD-ROM.

You can use the CONFIG.PS file to change the PostScript and HP-GL job and wait timeout values. When sent to the printer, your edited version of the CONFIG.PS file changes the values in the printer, but only while the printer is turned on; if the printer is turned off or reset the values return to their defaults. To restore your desired timeout settings, you must send your edited CONFIG.PS file to the printer again.

Note The CONFIG.PS file affects printer operation. If the printer is shared on a network, using this file may affect the prints requested by other users.

1.Locate the utility files in the PHSR350 directory on the printer’s CD-ROM.

2.Copy the CONFIG.PS file to your hard disk.

3.Open the file using a text editor. The default value is 40 seconds for the wait timeout. Change the value in the WaitTimeOut line to 999.

4.Use one of the following methods to send the CONFIG.PS file to the printer:

PC users: Use the DOS COPY command to send the file to the printer. (Windows 3.1 users can also use the Copy command in the File Manager.)

Workstation users: Send the file to the printer as you would any PostScript file.

User Manual

6-31

Page 213
Image 213
Tektronix Phaser 350 manual Printer’s timeout