6.3.25 SAVE START COMMAND (For Flash Memory) | [ESC] XO |
Function
Declares the start of saving PC interface commands.
(Places the printer in the mode where PC interface commands are written in flash memory.)
Format
Term
Notes
Refer to
Examples
[ESC] XO; aa, (Sb, ) c [LF] [NUL]
aa:Identification number to be used for saving in flash memory or calling 01 to 99
Sb: Drive in which the PC interface command is stored (Omissible. If omitted, flash ROM on the CPU board is selected.)
b:Drive
0:Flash ROM on the CPU board
1:Slot 1 on the PCMCIA board (Option)
2:Slot 2 on the PCMCIA board (Option)
c:Status response at save time
0:No status response made
1:Status response made
(1)After sending the Save Start Command ([ESC] XO), any command other than the following will be saved into flash memory without being analyzed.
•Save Start Command ([ESC] XO)
•Save Terminate Command ([ESC] XP)
•Saved Data Call Command ([ESC] XQ, [ESC] XT)
•Bit Map Writable Character Command ([ESC] XD, [ESC] XA)
•Reset Command ([ESC] WR)
•Status Request Command ([ESC] WS)
•Flash Memory Format Command ([ESC] J1)
•ATA Card Format Command ([ESC] JA)
(2)No error check is made for the commands at save time.
(3)Up to 64 KB can be saved per a save.
•Save Terminate Command ([ESC] XP)
• Flash Memory Format Command ([ESC] J1)
[ESC] J1; B [LF] [NUL]
[ESC] XO; 01, 0 [LF] [NUL]
[ESC] D0508, 0760, 0468 [LF] [NUL]
[ESC] T20C30 [LF] [NUL]
[ESC] C [LF] [NUL]
[ESC] PC001; 0200, 0125, 1, 1, A, 00, B [LF] [NUL]
[ESC] PC002; 0650, 0550, 2, 2, G, 33, B, +0000000001 [LF] [NUL]
[ESC] XP [LF] [NUL]
- 218 -
