Toshiba B-SX4T-GS20-QM-R manual An Eeprom for back-up cannot be Read/written properly

LCD Messages		Printer Status		Output Signal
of Upper Line (English)			Busy	Select	nFault	PError
EEPROM ERROR	An EEPROM for back-up cannot be		H	L	L	L
	read/written properly.
SYSTEM ERROR	(a)	A command has been fetched from an	H	L	L	L
		odd address.
	(b)	Word data has been accessed from a
		place other than the boundary of the word
		data.
	(c)	Long word data has been accessed from
		a place other than the boundary of the
		long word data.
	(d)	An undefined command in a place other
		than the delay slot has been decoded.
	(e)	An undefined command in the delay slot
		has been decoded.
	(f)	A command which rewrites the data in the
		delay slot has been decoded.
RFID WRITE ERROR	Writing data onto the RFID tag continuously		H	L	L	L
	failed for the maximum number of RFID write
	retries.
RFID ERROR	The printer cannot communicate with the		H	L	L	L
	RFID module.
INPUT PASSWORD	The printer is waiting for a password to be		H	L	L	L
	entered.
PASSWORD INVALID	Password entered was not correct		H	L	L	L
	consecutively for three times.
RFID CONFIG ERR	B-SX704-RFID-U2-US-R only		H	L	L	L
	RFID module’s destination code is not
	specified

9.3 E-MAIL

The printer can notify the PC of the printer status by e-mail. The status to be notified by e-mail is the same as the status which is notified through the serial interface. For details, refer to the Network Specification (TAA-1401).

- 273 -