Toshiba B-SX4T-GS20-QM-R manual SX5T

B-SX4T:

(*1): When a cut issue is performed at 3 ips by using the rotary cutter, label length B should be as follows:

Label length	B ≥ 91.0 mm -	Label-to-label gap
		2

(*2): When a cut issue is performed at 6 ips by using the rotary cutter, label length Bshould be as follows:

Label length B ≥ 103.0 mm -	Label-to-label gap
	2

(*3): When a cut issue is performed by using the swing cutter, label length B should be as follows:

Label length	B ≥ 35.0 mm -	Label-to-label gap
		2

B-SX5T:

(*4): When a cut issue is performed at 3 ips by using the rotary cutter, label length B should be as follows:

Label length	B ≥ 91.0 mm -	Label-to-label gap
		2

(*5): When a cut issue is performed at 5 ips by using the rotary cutter, label length Bshould be as follows:

Label length	B ≥ 99.0 mm -	Label-to-label gap
		2

(*6): When a cut issue is performed at 8 ips by using the rotary cutter, label length Bshould be as follows:

Label length B ≥ 110.0 mm -	Label-to-label gap
	2

(*7): When a cut issue is performed by using the swing cutter, label length B should be as follows:

Label length	B ≥ 35.0 mm -	Label-to-label gap
		2

- 40 -