Toshiba B-SX4T-GS20-QM-R manual

~In the case of MaxiCode Code (Two-dimensional code)

Format

Term

c[ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) [LF] [NUL]

aa:Bar code number 00 to 31

bbbb:Print origin of X-coordinate of the bar code Fixed as 4 digits (in 0.1 mm units)

cccc:Print origin of Y-coordinate of the bar code 4 or 5 digits (in 0.1 mm units)

d:Type of bar code

Z:MaxiCode (Two-dimensional code)

e:Mode selection (Omissible)

•When the MaxiCode specification setting is set to “TYPE1: Compatible with the current version” in the system mode.

Omitted: Mode 2

0:Mode 2

1:Mode 4

2:Mode 2

3:Mode 3

4:Mode 4

5:Mode 2

6:Mode 6

7:Mode 2

8:Mode 2

9:Mode 2

•When the MaxiCode specification setting is set to “TYPE2: Special specification” in the system mode.

Omitted: Mode 2 or Mode 3(*)

0:Mode 2 or Mode 3(*)

1:Mode 4

2:Mode 2

3:Mode 3

4:Mode 4

5:Mode 2 or Mode 3 (*)

6:Mode 6

7:Mode 2 or Mode 3 (*)

8:Mode 2 or MODE 3 (*)

9:Mode 2 or MODE 3 (*)

*: Mode 2 or Mode 3 should be determined depending on the country code of the data command. When the country code is 840, Mode 2 should be selected. For other codes than 840, Mode 3 should be selected.

Jffgg:	Connection setting (Omissible. No connection if this parameter is omitted.)
	ff:	Code number	01 to 08
	gg:	No. of divided codes	01 to 08
Zh:	Attachment of Zipper block and Contrast block
	(Omissible. If omitted, they are not attached.)
	h=	0: No attachment of Zipper block and Contrast block
		1: Attachment of Zipper block and Contrast block
		2: Attachment of Zipper block
		3: Attachment of Contrast block
		- 107 -