Toshiba B-SX4T-GS20-QM-R manual Detail Status

9.1.2DETAIL STATUS

LCD Message of				Detail Status
Upper Line			Printer Status	Auto Status	Status
(English)				Transmission	Request
					Command
ON LINE			The head was closed with the head open.	00	00
HEAD OPEN			The head was opened in the online mode.	01	01
ON LINE			Operating (Analyzing command, drawing, printing,	–	02
			feeding)
PAUSE		****	In a pause state	–	04
ON LINE			Waiting for stripping	–	05
Display of error message			A command error was found in analyzing the	06	06
(See NOTE 1.)			command.
COMMS ERROR			A parity error or framing error occurred during	07	07
			communication by RS-232C
PAPER JAM		****	A paper jam occurred during a paper feed.	11	11
CUTTER ERROR****			An abnormal condition occurred at the cutter.	12	12
NO PAPER		****	The label has run out.	13	13
NO RIBBON		****	The ribbon has run out.	14	14
HEAD OPEN		****	An attempt was made to feed or issue with the	15	15
			head open (except the [FEED] key)
HEAD ERROR		****	A broken dot error has occurred in the thermal	17	17
			head.
EXCESS HEAD TEMP			The thermal head temperature has become	18	18
			excessively high.
RIBBON ERROR****			An abnormal condition occurred in the sensor for	21	21
			determining the torque for the ribbon motor.
REWIND FULL ****			An overflow error has occurred in the rewinder.	22	22
ON LINE			Ribbon near end state (Online)	–	27
PAUSE			Ribbon near end state (In a pause state)	–	28
ON LINE			Ribbon near end state (Operating)	–	29
ON LINE			A label issue has been completed normally.	40	–
ON LINE			A feed has been completed normally.	41	–
ON LINE			A head broken dots check has been completed	00	–
			normally.
SAVING	#### &&&&		In writable character or PC command save	–	55
SAVING	%%%%%%%		mode
FLASH WRITE ERR.			An error has occurred in writing data into memory	50	50
			for storage.
FORMAT ERROR			An erase error has occurred in formatting memory	51	51
			for storage.
FLASH CARD FULL			Saving failed because of the insufficient capacity of	54	54
			memory for storage.
POWER FAILURE			A momentary power interruption has occurred.	–	–
INITIALIZING...			The memory card for storage is being initialized.
			(Initialization is carried out for a max. of
			approximately 15 seconds)

- 269 -