Toshiba B-SX4T-GS20-QM-R manual Dhcp Function SET Command ESC IH

6.3.41 DHCP FUNCTION SET COMMAND [ESC] IH

Function

Format

Term

Enables or disables the DHCP function, and sets the DHCP client ID.

[ESC] IH; a, bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb [LF] [NUL]

a:0: DHCP function is disabled.

1:DHCP function is enabled.

bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb:DHCP client ID

(16 bytes of data should be described in 32 bytes in Hex.)

Explanation

Example

•These settings can also be made in the system mode. The setting which was last made takes effect.

•“FFH” in the client ID is assumed as a terminator. Therefore, “FFH” must not be used in data.

•If “FFH” is specified as the first byte of the DHCP client ID, the printer assumes the DHCP client ID is not specified, and uses the MAC address of the LAN board installed on the printer as the DHCP client ID.

To enable the DHCP function and set the DHCP client ID to “12H56HCDH”. [ESC] IH; 1, 1256CDFFFFFFFFFFFFFFFFFFFFFFFFFF [LF] [NUL]

- 236 -