Toshiba B-SX4T-GS20-QM-R manual Alignment, Left Center

(12) Alignment

Designated origin

Left Center

Automatic line feed

Line feed length Automatic line feed Automatic

Right

No. of lines

Character string length in the X direction (in 0.1 mm units)

E q u a l s p a c e

If characters are not placed on one line when equal space and automatic line feed is designated, the following steps should be performed.

Decrease the value of the character-to-character space. When characters are not placed on one line if the value is set to 0, return the value to its default, and then reduce the horizontal magnification for a character by 0.5.

If characters are still not placed on one line, repeatedly decrease the value of the character-to-character space, and then reduce the horizontal magnification. When characters are not placed on one line if the character magnification is set to 0.5 and the character-to-character space is set to 0, the field is not drawn. (The same previous field is not drawn.)

When “01”, “12”, “23”, or “30” is specified for the rotational angles of a character and character string, the alignment setting (Center, Right, Equal space, or Automatic line feed) is ignored.

(13)Data string to be printed

Drawing data can be programmed by designating the number of digits after the symbol “=.” Up to 255 digits can be printed. However, when the font type is “r”, the maximum number of digits is 127. If the number of digits exceeds the maximum value, the excessive data will be discarded.

For the character code table, refer to chapter 12 “CHARACTER CODE TABLE”.

- 70 -