Toshiba B-SX4T-GS20-QM-R manual Xxh Etx

Explanation

(1)The parameter, “Number of bytes to be read”, is effective only when RFID read mode is set to 1 or 3, as this parameter is intended for reading user data. When reading tag ID, this parameter is ignored.

(2)When the value exceeding the maximum number of bytes storable in a tag is designated for “Number of bytes to be read”, a read error results.

(3)With RFID (data read) being specified by this command, when an RFID data read failed, the printer will retry to read data after sending a void pattern printing end status (60H) or result in an error and stop after sending an RFID write error status (61H).

SOH	01H	Indicates the start of the status block
STX	02H
Status	34H	Printer status
	32H
Status type	34H	Indicates the end of an RFID read and issue.
	3XH
Remaining	3XH	Remaining issue count
count	3XH
	3XH
		30H30H: RFID read failed.
		31H31H: I-Code
	XXH	31H32H: Tag-it
		31H33H: C220
		31H34H: ISO15693
Tag type		31H35H: C210
		31H36H: C240
		31H37H: C320
	XXH	32H31H: EPC Class 0
		32H32H: EPC Class 1
		32H33H: ISO18000-6B
		32H34H: EPC Class 1 Generation 2
Length	XXH	RFID data length
	XXH
	XXH
	XXH	Tag ID + User data
	:
RFID data		* Data to be read is different depending on the RFID
	:
		read mode setting.
	XXH
	XXH
ETX	03H
EOT	04H	Indicates the end of the status block.
CR	0DH
LF	0AH

(4)When an access password is designated using this command, writing data onto a tag cannot be performed if the access password registered in the tag differs from the access password designated. However, reading data can be performed.

(If the tag is the Hibiki tag and read lock is set, reading the tag is also disabled.)

- 117 -