5. TRANSMISSION SEQUENCE
This section describes the outline of the transmission sequence.
5.1 INITIALIZATION
Writable characters, logo, and PC interface commands must be stored before the label issue operation.
(1)Storing writable characters and logo
Power ON
No
<New>
(Add/change)
Yes
[ESC] J1: Formats the
Format Command
card (manufactured by Maxell).
or
[ESC] JA: Formats the ATA card.
Bit Map Writable
Character Command
No Completion of storing all characters
Yes
[ESC] XD: Stores writable characters or a logo on the flash memory card.
or
[ESC] XA: Stores writable characters or a
logo on the ATA card.
zStoring PC interface commands
zLabel issue operation
NOTES: (1) The storage of writable characters or logos is only performed if it is required.
(2)When the flash memory card is used, and the Format Command is not sent before storing already stored writable characters or logos, memory will be taken up with every such storing.
(3)When the flash memory card is used, and another operation (storing PC interface commands or label issue operation) is performed after storing writable characters or logos, the image buffer will be cleared automatically.
(4)If another storing operation does not take place after storing writable characters or logos, the printer automatically enters the online mode (label issue operation) after about 10 seconds. In this case, when the flash memory card is used, the image buffer will be cleared automatically.
- 30 -
