(2)Storing PC interface commands

Power ON

No

<New>

(Add/change)Yes

Format Command

Save Start Command

Label Size Set Command

Position Fine Adjust Command

Print Density Fine Adjust

Command

Image Buffer Clear Command

Line Format Command

Bit Map Font Format Command

Outline Font Format Command

Bar Code Format Command

Bit Map Font Data Command

Save Terminate Command

No

Completion of

 

all storing

Yes

[ESC] J1: Formats the flash memory card. or

[ESC] JA: Formats the ATA card.

[ESC] XO, [ESC] XV: Declares the start of saving PC interface commands.

[ESC] D: Sets the label size.

[ESC] AX: Adjusts the feed length, cut position, and back feed length.

[ESC] AY: Adjusts the print density.

[ESC] C: Clears the image buffer.

[ESC] LC: Sets the line format and draws it.

[ESC] PC: Sets the bit map font format.

[ESC] PV: Sets the outline font format.

[ESC] XB: Sets the bar code format.

[ESC] RC: Draws data of the bit map font.

[ESC] XP: Declares the termination of saving PC interface commands.

zStoring writable characters or logos

zLabel issue operation

NOTES: (1) The storage of PC commands is only performed if it is required.

(2)When the flash memory card is used, and the Format Command is not sent before storing already stored PC interface commands, memory will be taken up with every such storing.

(3)When the flash memory card is used, and another operation (storing writable characters or logos, label issue operation) is performed after storing PC interface commands, the image buffer will be cleared automatically.

(4)Select commands to be stored as the occasion demands.

(5)If another storing operation does not take place after storing PC interface commands, the printer enters the online mode (label issue operation) after about 10 seconds. In this case, when the flash memory card is used, the image buffer will be cleared automatically.

-31 -

Page 35
Image 35
Toshiba B-SX4T-GS20-QM-R manual