oo:1st byte code of the control code (*2)

“00” to “FF” (Specify the hex code in 2 bytes of ASCII code.) (*3)

pp:2nd byte code of the control code (*2)

“00” to “FF” (Specify the hex code in 2 bytes of ASCII code.) (*3)

qq:3rd byte code of the control code (*2)

“00” to “FF” (Specify the hex code in 2 bytes of ASCII code.) (*3)

r:Peel-off wait status selection

0:OFF (No peel-off wait status selection)

1:ON (Peel-off wait status selection)

s:[FEED] key function

0:FEED: Feeds one label.

1:PRINT: Prints data of the image buffer on one label.

t:Kanji code selection

0:TYPE1

1:TYPE2

uu:Euro code setting

“20” to “FF” (Specify the hex code in 2 bytes of ASCII code) (*3)

v:Automatic head broken dots check

0: OFF

(When the power is turned on, the broken dots check is not

 

automatically performed.)

1: ON

(When the power is turned on, the broken dots check is automatically

 

performed.)

w:Centronics ACK/BUSY timing setting

0:TYPE1

1:TYPE2

x:Web printer function setting

0:

OFF

(Web printer function is disabled.)

1:

ON

(Web printer function is enabled.)

y:Reset process when the nInit signal is ON

0:

OFF

(Reset process is not performed.)

1:

ON

(Reset process is performed.)

z:Ribbon near end detection setting

0:Not detected.

1:Detected when the remaining length of the ribbon is 30 m.

2:Detected when the remaining length of the ribbon is 70 m.

A:Expansion I/O operation mode setting

0:Standard mode

1:In-line mode

B:Centronics operation mode setting

0:SPP (Compatibility mode)

1:ECP (ECP mode)

- 241 -

Page 245
Image 245
Toshiba B-SX4T-GS20-QM-R Web printer function is disabled, Web printer function is enabled, Reset process is not performed