
(2)Cutter Error
•Rotary cutter
When the cutter does not move from the cutter home position 40 msec or more after the cutter solenoid is driven, an error will result.
The cutter moves from the home position, however, it does not return to the home position after 150 msec.
•Swing cutter
When the cutter home position sensor does not detect 1.5 sec or more after the cutter motor is driven, an error will result.
•A paper jam has occurred at the cutter. (The cutter does not return to the home position.)
•The cutter does not move from the home position.
•The cutter cover is open.
(3)Label End
Error processing differs depending on the setting of label end/ribbon end process in the system mode.
When TYP1 is selected. (default):
cWhen the transmissive sensor or the reflective sensor detects a continuous
dWhen an issue, a feed, or an ejection is attempted in a printer stop state while the transmissive sensor or the reflective sensor detects the label end state, an error will result.
When TYP2 is selected. (effective only when the ribbon saving function is not used.):
cWhen the transmissive sensor or the reflective sensor detects a continuous
dWhen an issue, a feed, or an ejection is attempted in a printer stop state while the transmissive sensor or the reflective sensor detects the label end state, an error will result.
(4)Ribbon End
Error processing differs depending on the setting of label end/ribbon end process in the system mode.
When TYP1 is selected. (default):
cWith the ribbon being selected, when the ribbon end sensor detects a continuous
dWith the ribbon being selected, when an issue, a feed, or an ejection is attempted in a printer stop state while the ribbon end sensor detects the ribbon end state, an error will result.
When TYP2 is selected. (effective only when the ribbon saving function is not used.)
cWith the ribbon being selected, when the ribbon end sensor detects a continuous
•When unfinished label length is 30 mm or more, an error results after the printer prints the label for 20 mm.
•When unfinished label length is less than 30 mm, the printer completes the
dWith the ribbon being selected, when an issue, a feed, or an ejection is attempted in a printer stop state while the ribbon end sensor detects the ribbon end state, an error will result.
- 263 -