Toshiba QOSMIO G20 manual Installing a HDD

4.4 HDD 4 Replacement Procedures

Installing a HDD

The following describes the procedure for installing a HDD (See Figure 4-4 to 4-6).

1. Install an HDD to the HDD holder and secure it with the following screws.

‰ M3.0x4.0Z FLAT BIND screw x4

NOTE: Although they are 3mm head screws, screw torque must be set in 0.294 N·m (3.0Kgf·cm) for four screws securing the HDD holder.

2.Slide the HDD-2 assembly into the HDD-2 slot from the screw hole side first and connect it carefully to the CN1860 on the system board.

3.Secure the HDD-2 assembly with the following screw.

‰ M2.5x6.0B FLAT BIND screw x１

4.Install the HDD-2 slot cover and secure it with the screw (with e-ring).

5.Insert the HDD-1 assembly into the HDD slot while sliding along the cutting tab and connect it carefully to the CN1850 on the system board.

6.Secure the HDD-1 assembly with the following screw.

‰ M2.5x6.0B FLAT BIND screw x１

7.Install the HDD-1 slot cover and secure it with the screw (with e-ring).

4-16 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)