Toshiba QOSMIO G20 manual All Devices, Setup by OS, Built-in HDD

3.32 SETUP 3 Tests and Diagnostics

7.Configuration

This option lets you set the device configuration.

All Devices	BIOS sets all devices.
Setup by OS	Initializes devices, which is needed to load an operating
	system. Operating system initializes other devices.

NOTE: (1) When using installed OS, selecting “Setup by OS” is recommended.

(2)When executing test programs, be sure to select “ALL Device”. And after the test end, select “Setup by OS”.

8.Drives I/O

This option displays the address and interrupts level for hard disk drive and optical disk drive. It is for information only and cannot be changed.

Built-in HDD	1	This cannot be changed.
		If HDD 1 is not installed, "No Drive" is displayed.
Built-in HDD	2	This cannot be changed.
		If HDD 2 is not installed, "No Drive" is displayed.
CD-ROM		This cannot be changed. This is not displayed when a
		drive is not built-in.

9. PCI Bus

This option displays the interrupt level for the Card Bus in the computer. It is for information only and cannot be changed.

PCI BUS = IRQ10, IRQ11

10.Display

This group of options configures the computer’s display.

(a)Power On Display

This option is used to select the display when booting up.

Auto-SelectedSelects an external monitor if one is connected. Otherwise it selects the internal LCD. (Default)

LCD+AnalogRGB Selects both the internal LCD and the external CRT for simultaneous display.

3-114 [CONFIDENTIAL] QOSMIO G20 Maintenance Manual (960-511)