Appendix J Maintenance of TOSHIBA RAID | J.3Operation of Independent utility |
8.When completing the rebuild, press “OK” to return to the main menu of Independent Setup Utility.
Resume Rebuild
During being suspended,[Resume Rebuild] is displayed in [Main Menu]. To start rebuilding suspended, follow the procedure below.
1.Put the cursor to the [Resume Rebuild] in the main menu of Indent Utility and press [Enter] key.
2.When [Rebuild Range] menu is displayed, the range to be rebuilt is designated. When [Effective] is selected, rebuild limit becomes valid and it rebuilds up to the rebuild limit. When [Whole] is selected, it rebuilds maximum capacity of array. The [Rebuild Range] menu is not displayed when the rebuild limit is not set or the rebuild limit is the same as the maximum capacity of array. Normally designation of [Effective] is adequate.
3.Put the cursor on “OK” in [Confirmation] and press [Enter] key. The rebuild starts.
4.During rebuilding, [Status] of [Physical Drive] becomes [REBILDING] and the progress rate, expected remaining time and the number of errors are displayed. During rebuilding, the [Rebuilding] dialog to select [Suspend] or [Abort] is displayed. It may take time depending on the drive capacity.
5.To suspend the rebuilding, put the cursor on [Suspend] (when aborting, on the [Abort]) and press [Enter] key. When [Confirmation] is displayed, put the cursor on [OK] and press [Enter] key.
QOSMIO G20 Maintenance Manual | [CONFIDENTIAL] |
