4.17 Battery board / RTC battery | 4 Replacement Procedures |
4.17 Battery board / RTC battery
4.17.1Battery board Removing the Battery board
The following describes the procedure for removing the Battery board (See Figure
1.Disconnect the RTC battery cable from the connector CN9990 on the battery board.
2.Remove the following screws securing the battery board.
M2.5x4.0B FLAT BIND screw | x2 |
3.Slightly pulling up the battery board, disconnect the battery signal harness from the connector CN9691 and the battery power harness from the connector CN9690 on the battery board.
4.Remove the battery board from the cover assembly.
M2.5x4.0B FLAT BIND | CN9990 | |||||||||
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
| M2.5x4.0B FLAT BIND | |||
Battery signal harness |
| |||||||||
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Battery board | |
|
|
|
|
|
|
|
| |||
RTC battery cable
Battery power harness
Figure 4-27 Removing the battery board
[CONFIDENTIAL] | QOSMIO G20 Maintenance Manual |
