Toshiba QOSMIO G20 manual Table J-7 Items set in View Drive Info

Appendix J Maintenance of TOSHIBA RAID J.3Operation of Independent utility

Physical Drive

Select [Physical Drive] in Setup Utility to set physical drive.

View Drive Info.

Select this option in [Physical Drive] to display information of physical drive. Select the drive that you want to display in [Physical Drive] at the lower of display and press [Enter] key. In the server with fault lamp (lamp displaying disk condition), the fault lamp of corresponded drive blinks while [Drive Information] display appears. Press [Esc] key to close the display. The following information is displayed.

	Table J-7 Items set in View Drive Info.
Option	Explanation
Assignment	Displays Array number and drive number of array incorporated. The display
	format is LD [Array number] [Drive number]. For example, [LD0-1] means
	Disk drive 1 of array 0.
Status	Displays the drive status. The followings are displayed.
	-ONLINE: The drive is working normally.
	-OFFLINE：The drive is not configured as array and is not used.
	-FAIL: The drive is failed and dose not work.
	-REBUILDING: The rebuilding is suspended.
	-UNKNOWN: There is controversy in the RAID information of other drive
	and the status is not decided. It is displayed when this drive was removed
	and used in the past. When this drive has been found good one, setting to
	OFFLINE is possible by executing [Force Offline].
S.M.A.R.T.	Displays the setting of failure prediction function of drive. “Enable” or
	“Disable” is displayed. The default is “Enable”.
	When the level reach to worming level, [Alert] is displayed.
	When [S.M.A.R.T.] is set to [Disable], [Normal] is displayed.
Model	Displays Model number of drive.
FW Rev	Displays the firmware revision of drive.
Serial	Displays the serial number of drive.
ATA/UDMA	Displays ATA standard and transmission mode that the drive corresponds
	to.
Max LBA	Displays the total number of sectors of drive in hexadecimal mode.
	(1 sector = 512B)
Uncopied Blk	In rebuilding, display the address of area that can not be used because of
	error in the original drive. When an error has been displayed in [Uncopied
	Blk], check if any error in the file system in the Windows scan disk. It is not
	necessary to check all the sectors. When any error is detected, any file is
	damaged. It is recommended to back up the data and rebuild RAID and
	restore.

QOSMIO G20 Maintenance Manual (960-511) [CONFIDENTIAL] J-23