Chapter 10 Interface

 

Table 60 Network > Interface > PPP > Edit > Configuration (continued)

 

LABEL

DESCRIPTION

 

Ingress

This is reserved for future use.

 

Bandwidth

Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can

 

 

receive from the network through the interface. Allowed values are 0 - 1048576.

 

 

 

 

MTU

Maximum Transmission Unit. Type the maximum size of each data packet, in

 

 

bytes, that can move through this interface. If a larger packet arrives, the

 

 

ZyWALL divides it into smaller fragments. Allowed values are 576 - 1492.

 

 

Usually, this value is 1492.

 

 

 

 

Connectivity Check

The interface can regularly check the connection to the gateway you specified

 

 

to make sure it is still available. You specify how often the interface checks the

 

 

connection, how long to wait for a response before the attempt is a failure, and

 

 

how many consecutive failures are required before the ZyWALL stops routing to

 

 

the gateway. The ZyWALL resumes routing to the gateway the first time the

 

 

gateway passes the connectivity check.

 

 

 

 

Enable

Select this to turn on the connection check.

 

Connectivity

 

 

Check

 

 

 

 

 

Check Method

Select the method that the gateway allows.

 

 

Select icmp to have the ZyWALL regularly ping the gateway you specify to

 

 

make sure it is still available.

 

 

Select tcp to have the ZyWALL regularly perform a TCP handshake with the

 

 

gateway you specify to make sure it is still available.

 

 

 

 

Check Period

Enter the number of seconds between connection check attempts.

 

 

 

 

Check Timeout

Enter the number of seconds to wait for a response before the attempt is a

 

 

failure.

 

 

 

 

Check Fail

Enter the number of consecutive failures before the ZyWALL stops routing

 

Tolerance

through the gateway.

 

 

 

 

Check Default

Select this to use the default gateway for the connectivity check.

 

Gateway

 

 

 

 

 

Check this

Select this to specify a domain name or IP address for the connectivity check.

 

address

Enter that domain name or IP address in the field next to it.

 

 

 

 

Check Port

This field only displays when you set the Check Method to tcp. Specify the port

 

 

number to use for a TCP connectivity check.

 

 

 

 

Related Setting

 

 

 

 

 

Add this

Select this option to use the interface as part of a WAN trunk for load balancing.

 

interface to

 

 

WAN_TRUNK to

 

 

allow WAN load

 

 

balance.

 

 

 

 

 

Policy Route

Click this link to go to the screen where you can manually configure a policy

 

 

route to associate traffic with this interface.

 

 

 

 

OK

Click OK to save your changes back to the ZyWALL.

 

 

 

 

Cancel

Click Cancel to exit this screen without saving.

 

 

 

 

225

ZyWALL USG 100/200 Series User’s Guide