Chapter 43 System

Figure 520 System > Telnet

The following table describes the labels in this screen.

Table 241 System > Telnet

LABEL

DESCRIPTION

Enable

Select the check box to allow or disallow the computer with the IP address that

 

matches the IP address(es) in the Service Control table to access the ZyWALL

 

CLI using this service.

 

 

Server Port

You may change the server port number for a service if needed, however you must

 

use the same port number in order to use that service for remote management.

 

 

Service Control

This specifies from which computers you can access which ZyWALL zones.

 

 

#

This the index number of the service control rule.

 

The entry with a hyphen (-) instead of a number is the ZyWALL’s (non-configurable)

 

default policy. The ZyWALL applies this to traffic that does not match any other

 

configured rule. It is not an editable rule. To apply other behavior, configure a rule

 

that traffic will match so the ZyWALL will not have to use the default policy.

 

 

Zone

This is the zone on the ZyWALL the user is allowed or denied to access.

 

 

Address

This is the object name of the IP address(es) with which the computer is allowed or

 

denied to access.

 

 

Action

This displays whether the computer with the IP address specified above can access

 

the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).

 

 

Add icon

Click the Add icon in the heading row to open a screen where you can add a new

 

rule. Refer to Table 239 on page 682 for information on the fields.

 

Click the Edit icon to go to the screen where you can edit the rule.

 

Click the Add icon in an entry to add a rule below the current entry.

 

Click the Delete icon to remove an existing rule. A window display asking you to

 

confirm that you want to delete the rule. Note that subsequent rules move up by one

 

when you take this action.

 

Click the Move to N icon to display a field to type a number for where you want to

 

put that rule and press [ENTER] to move the rule to the number that you typed.

 

 

Apply

Click Apply to save your changes back to the ZyWALL.

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

43.9 FTP

You can upload and download the ZyWALL’s firmware and configuration files using FTP. To use this feature, your computer must have an FTP client. Please see Chapter 44 on page 705 for more information about firmware and configuration files.

694

 

ZyWALL USG 100/200 Series User’s Guide