Chapter 10 Interface
"
"
Install (or connect) a compatible 3G card to use a cellular connection. See Chapter 50 on page 749 for details.
The WAN IP addresses of a ZyWALL with multiple WAN interfaces must be on different subnets.
Figure 162 Network > Interface > Cellular
The following table describes the labels in this screen.
Table 62 Network > Interface > Cellular
LABEL | DESCRIPTION |
# | This field is a sequential value, and it is not associated with any interface. |
|
|
Name | This field displays the name of the interface. |
|
|
Extension Slot | This field displays where the entry’s cellular card is located. |
|
|
Connected | This field displays the name of the cellular card. |
Device |
|
|
|
ISP Settings | This field displays the profile of ISP settings that this cellular interface is set to use. |
|
|
Add icon | This column lets you create, edit, remove, activate, and deactivate cellular |
| interfaces. |
| To create an interface, click the Add icon at the top of the column. In the |
| window that displays, select the slot that you want to configure. |
| To activate or deactivate an interface, click the Active icon next to it. Make sure |
| you click Apply to save and apply the change. |
| To edit an interface, click the Edit icon next to it. The edit screen appears. |
| To remove an interface, click the Remove icon next to it. The ZyWALL confirms |
| you want to remove it before doing so. |
| To connect or disconnect an interface, click the Connect icon next to it. You might |
| use this icon to test the interface or to manually establish the connection. |
|
|
Apply | Click Apply to save your changes back to the ZyWALL. |
|
|
Reset | Click Reset to begin configuring this screen afresh. |
|
|
| 227 |
ZyWALL USG 100/200 Series User’s Guide | |
|
|