Chapter 10 Interface
The following table describes the labels in this screen.
Table 64 Interface > Cellular > Status
LABEL | DESCRIPTION |
Refresh | Click this button to update the information in the screen. |
|
|
# | This field is a sequential value, and it is not associated with any interface. |
|
|
Extension Slot | This field displays where the entry’s cellular card is located. |
|
|
Connected Device | This field displays the model name of the cellular card. |
|
|
Status | No device - no 3G device is connected to the ZyWALL. |
| Device detected - displays when you connect a 3G device. |
| Device error - a 3G device is connected but there is an error. |
| Probe device fail - the ZyWALL’s test of the 3G device failed. |
| Probe device ok - the ZyWALL’s test of the 3G device failed. |
| Init device fail - the ZyWALL was not able to initialize the 3G device. |
| Init device ok - the ZyWALL initialized the 3G card. |
| Check lock fail - the ZyWALL’s check of whether or not the 3G device is locked |
| failed. |
| Device locked - the 3G device is locked. |
| SIM error - there is a SIM card error on the 3G device. |
| SIM |
| SIM |
| Unlock PUK fail - Your attempt to unlock a WCDMA 3G device’s PUK failed |
| because you entered an incorrect PUK. |
| Unlock PIN fail - Your attempt to unlock a WCDMA 3G device’s PIN failed |
| because you entered an incorrect PIN. |
| Unlock device fail - Your attempt to unlock a CDMA2000 3G device failed |
| because you entered an incorrect device code. |
| Device unlocked - You entered the correct device code and unlocked a |
| CDMA2000 3G device. |
| Get |
| Get |
| Searching network - The 3G device is searching for a network. |
| Get signal fail - The 3G device cannot get a signal from a network. |
| Network found - The 3G device found a network. |
| Apply config - The ZyWALL is applying your configuration to the 3G device. |
| Inactive - The 3G interface is disabled. |
| Active - The 3G interface is enabled. |
| Incorrect device - The connected 3G device is not compatible with the ZyWALL. |
| Correct device - The ZyWALL detected a compatible 3G device. |
| Set band fail - Applying your band selection was not successful. |
| Set band ok - The ZyWALL successfully applied your band selection. |
| Set profile fail - Applying your ISP settings was not successful. |
| Set profile ok - The ZyWALL successfully applied your ISP settings. |
| PPP fail - The ZyWALL failed to create a PPP connection for the cellular interface. |
| Device ready - The ZyWALL successfully applied all of your configuration and you |
| can use the 3G connection. |
|
|
Service Provider | This displays the name of your network service provider or Limited Service when |
| the signal strength is too low. |
|
|
Cellular System | This field displays what type of cellular network the 3G connection is using. The |
| network type varies depending on the 3G card you inserted and could be UMTS, |
| UMTS/HSDPA, GPRS or EDGE when you insert a GSM 3G card, or 1xRTT, |
| EVDO Rev.0 or EVDO Rev.A when you insert a CDMA 3G card. |
|
|
232 |
| |
ZyWALL USG 100/200 Series User’s Guide |
| |
|
|
|