Chapter 4 Wizard Setup

Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal (“0-9”, “A-F”) characters. Proceed hexadecimal characters with “0x”.

Figure 36 VPN Express Wizard: Step 3

The following table describes the labels in this screen.

Table 16 VPN Express Wizard: Step 3

LABEL

DESCRIPTION

Local Policy

Type a static local IP address that corresponds to the remote IPSec router's

(IP/Mask)

configured remote IP address (the remote IP address of the other ZyWALL).

 

To specify IP addresses on a network by their subnet mask, type the subnet mask of

 

the LAN behind your ZyWALL.

 

 

Remote Policy

Type a static local IP address that corresponds to the remote IPSec router's

(IP/Mask)

configured local IP address (the local IP address of the other ZyWALL).

 

To specify IP addresses on a network by their subnet mask, type the subnet mask of

 

the LAN behind the remote gateway.

 

 

Next

Click Next to continue.

 

 

4.8.1 VPN Express Wizard - Policy Setting

The Policy Setting specifies which devices can use the VPN tunnel. Local and remote IP addresses must be static.

Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also specify a subnet. This must match the remote IP address configured on the peer IPSec device.

Remote Policy (IP/Mask): Type the IP address of a computer behind the peer IPSec device. You can also specify a subnet. This must match the local IP address configured on the peer IPSec device.

 

97

ZyWALL USG 100/200 Series User’s Guide