Chapter 30 ADP

The following table describes the screens in this screen.

Table 164 Anti-X > ADP > General

LABEL

DESCRIPTION

General Settings

 

 

 

Enable Anomaly

Select this check box to enable traffic anomaly and protocol anomaly

Detection

detection.

 

 

Policies

Use this list to specify which anomaly profile the ZyWALL uses for traffic

 

flowing in a specific direction.

 

 

Priority

This is the rank in the list of anomaly profile policies. The list is applied in order

 

of priority.

 

 

From, To

This is the direction of travel of packets to which an anomaly profile is bound.

 

Note: Depending on your network topology and traffic load,

 

applying every packet direction to an anomaly profile may

 

affect the ZyWALL’s performance.

 

 

Anomaly Profile

An anomaly profile is a set of anomaly rules with configured activation, log and

 

action settings. This field shows which anomaly profile is bound to which traffic

 

direction.

 

 

(Icons)

Click the Add icon in the heading row to add a new first entry.

 

The Active icon displays whether the entry is enabled or not. Click it to activate

 

or deactivate the entry. Make sure you click Apply to save and apply the

 

change.

 

Click the Edit icon to go to the screen where you can edit the entry.

 

Click the Add icon in an entry to add an entry below the current entry.

 

Click the Remove icon to delete an existing entry from the ZyWALL. A window

 

displays asking you to confirm that you want to delete the entry. Note that

 

subsequent entries move up by one when you take this action.

 

In a numbered list, click the Move to N icon to display a field to type an index

 

number for where you want to put that entry and press [ENTER] to move the

 

entry to the number that you typed. For example, if you type 6, the entry you

 

are moving becomes number 6 and the previous entry 6 (if there is one) gets

 

pushed up (or down) one.

 

The ordering of your entries is important as they are applied in order of their

 

numbering.

 

 

Apply

Click Apply to save your changes.

 

 

Reset

Click Reset to start configuring this screen again.

30.2.1 Configuring ADP Policies

Click Anti-X > ADP > General and then an Add or Edit icon to display the following screen. Use this screen to apply an ADP profile to a traffic direction.

Figure 397 Anti-X > ADP > General > Add

 

515

ZyWALL USG 100/200 Series User’s Guide