Chapter 34 Device HA

Table 186 Device HA > Active-Passive Mode (continued)

LABEL

DESCRIPTION

Auto

Select this to get the updated configuration automatically from the specified

Synchronize

ZyWALL according to the specified Interval. The first synchronization begins after

 

the specified Interval; the ZyWALL does not synchronize immediately.

 

 

Interval

When you select Auto Synchronize, set how often the ZyWALL synchronizes with

 

the master.

 

 

Apply

This appears when the ZyWALL is currently using active-passive mode device HA.

 

Click Apply to save your changes back to the ZyWALL.

 

 

Apply & switch to

This appears when the ZyWALL is currently configured for legacy mode device HA.

Active-Passive

Click Apply to save your changes back to the ZyWALL and set it to use active-

Mode

passive mode device HA.

 

 

Reset

Click Reset to begin configuring this screen afresh.

 

 

34.4 Configuring an Active-Passive Mode Monitored Interface

The Device HA Active-Passive Mode Monitored Interface Edit screen lets you enable or disable monitoring of an interface and set the interface’s management IP address and subnet mask. To access this screen, click Device HA > Active-Passive Mode > Edit.

Figure 436 Device HA > Active-Passive Mode > Edit

The following table describes the labels in this screen.

Table 187 Device HA > Active-Passive Mode > Edit

LABEL

DESCRIPTION

Enable

Select this to have device HA monitor the status of this interface’s connection.

Monitored

 

Interface

 

 

 

Interface Name

This identifies the interface.

 

 

Virtual Router IP

This is the interface’s (static) IP address and subnet mask in the virtual router.

(VRIP) / Subnet

Whichever ZyWALL is currently serving as the master uses this virtual router IP

Mask

address and subnet mask. These fields are blank if the interface is a DHCP client

 

or has no IP settings.

 

 

Manage IP

Enter the interface’s IP address for management access. You can use this IP

 

address to access the ZyWALL whether it is the master or a backup. This

 

management IP address should be in the same subnet as the interface IP address.

 

 

Subnet Mask

Enter the subnet mask of the interface’s management IP address.

 

 

OK

Click OK to save your changes back to the ZyWALL.

 

 

Cancel

Click Cancel to exit this screen without saving your changes.

 

 

582

 

ZyWALL USG 100/200 Series User’s Guide