Agilent Technologies E4443A(3HZ-6.7GHZ) 2.15 Meas Setup (Intermod (TOI))

Chapter 2 153

One-Button Measurement Functions

Meas Setup (Intermod (TOI))

One-Button Measurement Functions

2.15 Meas Setup (Intermod (TOI))

When Intermod (TOI) measurement has been selected in the Measure menu of the Spectrum

Analysis Mode, this key displays the appropriate measurement setup menu for third order

intercept (TOI).

The TOI measurement computes and displays the output intercept point (IP3), and places

markers upon the trace to indicate the measured signals and third-order products. The

span must be wide enough so that the signals and their intermod products are visible on

the display. Otherwise the TOI signal pattern cannot be identified so the measurement

routine will not function.

Key Path: Front-panel key

Dependencies/

Couplings: Menu changes depending on the Mode and Measurement selected.

History: Added with PSA firmware revision A.02.00

Added with ESA firmware revision A.08.00

Remote Command:

There is no equivalent remote command.

Set Avg Num ber to On to specify the number of measurement averages used when

calculating the measurement result. The average will be displayed at the end of each

sweep. Setting Avg Numb er to Off disables measurement averaging.

Key Path: Meas setup

State Saved: Saved in instrument state.

Factory Preset: 10 averages / Off

Range: 1 through 1000

History: Added with PSA firmware revision A.02.00

Added with ESA firmware revision A.08.00

Remote Command:

[:SENSe]:TOIN:AVERage:COUNt <integer>

[:SENSe]:TOIN:AVERage:COUNt?

[:SENSe]:TOIN:AVERage[:STATe] OFF|ON|0|1