78 Chapter 2
One-Button Measurement Functions
MEASURE (Spectrum Analysis Mode)
One-Button Measurement Functions
key). Other measurements are available in other modes if an optional personality is installed.Key Path: MEASURE
Remote Command: Example: FETC:BPOW? or MEAS:BPOW? or READ:BPOW? Measurement Results Available
Command n Results Returned
:CONFigure:BPOWer
:INITiate:BPOWer
N/A Not Applicable
:FETCh:BPOWer[n]?
:MEASure:BPOWer[n]?
:READ:BPOWer[n]?
n=1 (or not
specified) Returns 10 scalar results, in the following
order.
1. Sample time
2. Power (RMS of carrier power)
3. Power averaged
4. Number of samples,
5. Amplitude threshold (relative)
6. Maximum trace point on the measured
part of the burst.
7. Minimum trace point on the measured part
of the burst.
8. Burst width (actual measured width, using
the threshold level)
9. Measured time
10. Measured points
n=2 Returns the displayed RF envelope trace data
separated by commas. The number of data
values is determined by the setting of the trace
points parameter.