42 Chapter 2
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page33.
Example: RAD:STAN WL802DOT11B
2.1.1.15.3 802.11g Sets the specific parameters for the selected measurement (located
under the “MEASURE (Spectrum Analysis Mode)” key description) appropriate for
industry standard 802.11g. This standard is only available for the Spectrum Emission
Mask (SEM) measurement.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std
History: Added with PSA firmware revision A.04.00
Added with ESA firmware revision A.10.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page33.
Example: RAD:STAN WL802DOT11G
2.1.1.15.4 Hiper LAN/2 Sets the specific parameters for the selected measurement
(located under the “MEASURE (Spectrum Analysis Mode)” key description) appropriate
for industry standard Hiper LAN2. This standard is only available for the Spectrum
Emission Mask (SEM) measurement.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std
History: Added with PSA firmware revision A.03.00
Added with ESA firmware revision A.09.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page33.
Example: RAD:STAN HIPERLAN2
2.1.1.16 DVB-T
Accesses the DVB-T key menu to enable you to select a DVB-T mask filtering standard.
Selecting a DVB-T filtering standard modifies spectrum analyzer settings for the CHP or
CCDF measurement activated under the MEASURE menu.
2.1.1.16.1 L/SECAM/NICAM
Pressing L/SECAM/NICAM selects the filtering masks for the L/SECAM/NICAM analog