40 Chapter 2
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
2.1.1.13 TETRA
Sets the specific parameters for the selected measurement (located under the “MEASURE
(Spectrum Analysis Mode)” key description) appropriate for industry standard TETRA.
This standard is only available for the Channel Power and ACP measurements.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std
History: Added with PSA firmware revision A.03.00
Added with ESA firmware revision A.09.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page33.
Example: RAD:STAN TETR
2.1.1.14 FCC Part 15 Subpart F
PSA Only: Sets the specific parameters for the selected measurement (located under the
“MEASURE (Spectrum Analysis Mode)” key description) appropriate for unlicensed
devices. This standard is only available for the Spurious Emissions measurement.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std
History: Added with PSA firmware revision A.06.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page33.
Example: RAD:STAN FCC15
2.1.1.15 WLAN
Accesses the WLAN radio standards key menu to enable you to select a WLAN standard.
Selecting a radio standard modifies spectrum analyzer settings for the CHP or CCDF
measurement activated under the MEASURE menu.
2.1.1.15.1 802.11a Sets the specific parameters for the selected measurement (located
under the “MEASURE (Spectrum Analysis Mode)” key description) appropriate for
industry standard 802.11a. This standard is only available for the Spectrum Emission
Mask (SEM) measurement.
Key Type: 1 of N menu
Key Path: Mode Setup, Radio Std