Chapter 2 199
One-Button Measurement Functions
Meas Setup (Spectrum Emissions Mask—SEM)
One-Button Measurement Functions
Remote Command:
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier <real number>,[<real
number>]...
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier?
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier:COUPle OFF|ON|0|1
[:SENSe]:SEMask:OFFSet[n]:LIST:STOP:RCARrier:COUPle?
Remote Command Notes: Comma separated list. When offset F is off, this will be 5
values. When offset F is on, this will be 6 values. n = 1 for BTS and n = 2
for MS. Default is BTS.
Example: SEM:OFFS:LIST:STOP:RCAR –20 dBm
SEM:OFFS:LIST:STOP:RCAR
SEM:OFFS:LIST:STOP:RCAR:COUP 0
SEM:OFFS:LIST:STOP:RCAR:COUP?
2.19.4.11 Fail Mask
Displays the menu to select one of the following logic keys for fail conditions between the
measurement results and the test limits: Absolute, Relative, Abs AND Rel, and Abs OR Rel.
Absolute - Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between Abs Start and Abs Stop, inclusive. This is the
default selection for each offset for BTS measurements.
Relative - Fail is shown if one of the relative spectrum emission mask measurement
results is larger than the limit between Rel Start and Rel Stop, inclusive.
Abs AND Rel - Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between Abs Start and Abs Stop, inclusive AND one of the
relative spectrum emission mask measurement results is larger than the limit for Rel
Start and Rel Stop. This is the default for MS measurements.
Abs OR Rel - Fail is shown if one of the absolute spectrum emission mask measurement
results is larger than the limit between Abs Start and Abs Stop, inclusive OR one of the
relative spectrum emission mask measurement results is larger than the limit for Rel
Start and Rel Stop.
Key Path: Meas Setup, Offset/Limits, More
State Saved: Saved in instrument state.
Factory Preset: Dependent upon Radio Standard and device selected, refer to the default
tables for “Offset/Limits” on page 187 for this value.