Agilent Technologies E4443A(3HZ-6.7GHZ)

38 Chapter 2

One-Button Measurement Functions

Mode Setup (Spectrum Analysis Mode)

One-Button Measurement Functions

2.1.1.10 NADC

Sets the specific parameters for the selected measurement (located under the “MEASURE

(Spectrum Analysis Mode)” key description) appropriate for industry standard NADC.

Channel Power and Intermod TOI measurements are not available when Device (MS) is

selected. All other measurements are available when this radio standard is selected

except: Spectrum Emissions Mask, Harmonic Distortion, Spurious Emissions, and

Multi-Carrier Power.

Key Type: 1 of N menu

Key Path: Mode Setup, Radio Std

History: Modified with PSA firmware revision A.04.00

Added with PSA firmware revision A.02.00

Modified with ESA firmware revision A.08.00

Added with ESA firmware revision A.07.00

Remote Command:

Use[:SENSe]:RADio:STANdard[:SELect] See “Radio Std” on page33.

Example: RAD:STAN NADC

2.1.1.11 PDC

Sets the specific parameters for the selected measurement (located under the “MEASURE

(Spectrum Analysis Mode)” key description) appropriate for industry standard PDC. The

Burst Power measurement is not available when Device (BTS) is selected. The Channel

Power and Intermod TOI measurements are not available when Device (MS) is selected. All

other measurements except Multi-Carrier Power, Harmonic Distortion, Spurious

Emissions and Spectrum Emission Mask measurements are available for this standard.