48 Chapter 2
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
to select the band class.
Key Path: Mode Setup, Std Setup
Factory Preset: US/K or Cell
History: Modified with PSA firmware revision A.04.00
Added with PSA firmware revision A.02.00
Modified with ESA firmware revision A.08.00
Added with ESA firmware revision A.07.00
Remote Command:
[:SENSe]:RADio:STANdard:BAND:CLASs BC0|BC1
[:SENSe]:RADio:STANdard:BAND:CLASs?
Example: RAD:STAN:BAND:CLAS BC1
2.1.3 Retain Params
Enables you to retain the base-instrument parameter settings used by individual
measurements that are typically lost when switching between measurements.
When Retain Params is set to Off, the values of the fully configurable parameters are not
saved and recalled during a measurement change.
When Retain Params is set to On, the fully configurable parameters will be saved and
recalled during a measurement change, along with Span, Ref Level, Single/Cont, Detector,
Avg/VBW Type, Points, and if applicable, Spectrum/Bar/Combined and Graticule On/Off.
NOTE When Radio Std or Radio Std Setup is changed, Retain Params is set to Off. Once
Retain Params has been set to Off, parameters will no longer be retained and
any settings you may have entered will be lost.
Key Path: Mode Setup
Factory Preset: Off
History: Added with PSA firmware revision A.04.00
Added with PSA firmware revision A.10.00
Remote Command:
[:SENSe]:RADio:STANdard:RPARams[:STATe]ON|Off|1|0
[:SENSe]:RADio:STANdard:RPARams[:STATe]?
Example: RAD:STAN:RPAR Off