
5Cable Testing in Expert Mode
The Expert Autotest Setup
3In the Profile Setup screen, press the desired profile. If the scroll bar is not full length, use the scroll rocker to scroll down to see more stored profiles
4Press OK when done.
5Press Start Test to run the Autotest.
Editing an Existing Settings Profile to Remove a Lock
You may also edit or delete existing profiles, including the Default profiles. It is recommended that you do not edit nor delete the Default profiles, as you must reload the software to get them back in their original form to meet the standards. To create a profile similar to a default profile, first select the desired default profile to set the locked settings. Then create a new profile as described in the next section.
To edit an existing settings profile:
1In Expert Mode, press Autotest. On the Autotest Settings screen, press Edit Settings, then press Profile, then press Edit.
1On the Profile Setup Screen, press the selected profile, then press Update Selected, then press Next.
2Change the lock settings by pressing the appropriate boxes. The check marks toggle with subsequent presses. Then press Next. If the Test Probe setting is locked, you will see the center screen below, which will prompt you to select the Performance Grade of the probe as well as the Probe Test Count Limit, if desired. Then press Next. If
120 | Agilent FrameScope 350 User’s Manual |