Introducing the FrameScope 350

1

Getting Started

Using the FrameScope 350

You operate the FrameScope using its front panel touchscreen and control buttons. When testing with the unit, use the following operating tips:

Select items on the display by pressing them with your finger or with a stylus or by scrolling the highlight bar with the scroll button. The touch screen may not detect a quick press; you should press firmly.

Many screens have lists of items that you can navigate using the Scroll button. Pressing this button up or down moves the selection highlight.

Selected items are highlighted in dark blue to indicate that they are selected. Most screens have a default selected item.

Execute a selected item by pressing it or by pressing the OK button.

To return the Main Menu at any time, press the Main Menu button on the bottom of the display.

To return to the previous screen, press the Back button on the bottom of the display.

Running a Test

The basic steps for performing a test with the FrameScope 350 are described below. For more information on network testing, see Chapter 2, “Network Testing with the FrameScope 350”. For more information on cable testing, see Chapter 3, “Cable Testing with the FrameScope 350”.

1Switch the unit on. Connect power to charge the battery if necessary. See “Checking Power and Charging the Battery” on page 11.

2Install the appropriate SmartProbe for your test and connect the FrameScope to the network under test. See “Connecting to the Network” on page 12.

3Choose the type of test you want by pressing either the Network or Cable test tab.

4Make any needed configuration changes to match your testing environment.

Most basic FrameScope operations execute automatically and require very little setup. In most cases you can skip this step.

5Press the Autotest button or Start Test button to begin the test.

Agilent FrameScope 350 User’s Manual

13

Page 21
Image 21
Agilent Technologies N2610A user manual Using the FrameScope, Running a Test