
5Cable Testing in Expert Mode
The Expert Autotest Setup
350 use the existing settings for all the parameters. See the remainder of this section to configure the other settings.
2In Expert Mode, press Autotest. On the Autotest Settings screen, press Edit Settings, then press Profile, then press Edit.
3On the Profile Setup Screen, press Create New Profile, then press Next. Press anywhere in the Profile Name area to open a keyboard to allow you to enter the new profile name. After entering the new name, press OK, then press Next.
4Change the lock settings by pressing the appropriate boxes. The check marks toggle with subsequent presses. Then press Next. If the Test Probe setting is locked, you will see the center screen below, which will prompt you to select the Performance Grade of the probe as well as the Probe Test Count Limit, if desired. Then press Next. If the Test Probe setting is not locked you will go directly to the
122 | Agilent FrameScope 350 User’s Manual |